top of page
Moore
Engineering
3D Printed Ring
The challenge was to design a 3D printed ring or charm. I picked the ring because I and wanted to do one earlier. I researche ideas and came up with these.
Laser-Cut-Wooden-Landscape-Ring-1.jpg
henderson1.jpg
tlc165-4.jpg
Laser-Cut-Wooden-Landscape-Ring-1.jpg
1/3
I ended up going with this design because I thought it was simple and still very pretty.
This is my design in google skechup before it is to the specific dimensions.
My finger measured as .55 so I altered the scale to fit me. And then preceded to 3D print it.
It was finally printed out; however the thickness was miscalculated and it ened up being too thin. And the house looks a bit too small. But all in all this has been a great learning experience.
This is he final product after the thickness level was fixed. If I could do somehimng differently I would Make the house bigger and the ring ot as widely thick
bottom of page